This VS-MI-100-8-Syneron B is another 8 bars laser stack special for syneron-candala 808nm diode laser hair removal handpieces. There is a little difference in size between Model A.
Oriental-laser focused on diode laser bar assembling for more than 16 years and we have seen various alma soprano diode laser stacks.Also we can use the same Jenoptik bar like Alma used to recondition the power the laser soprano power
808 Syneron laser handle Repairing procedure
>Choice A: Send the old broken handpiece to our factory. We will do the process of checking , repairing, cleaning and etc. Then send the fresh new handpiece back to you.
>Choice B: if you have basic assembly capacity, you can send the diode laser stack only to our factory. We remove the old bar and mount the new bar to recover the laser power of the stack.
>Choice C: Measure your stack and confirm the water pipe hole and screw hole position. Then press the button below to buy a ready-made stack which is match your old handpiece.
>Save Money. Replace the broken diode stack only. Low cost and convenient
>Long lifetime. we use diode laser bars from Germany. The newest Ausn mounting technology will be applied when repairing. After repair. The handpiece will be as a new one. lifetime is much longer than before
>All technical support available. We major in diode laser mounting, software, spare parts over 16 years. All the technologies about laser hair removal machine are open to you.
8bars diode laser stack Specification
Syneron-candala 808nm diode laser hair removal Handpiece Repair And Replacement
Hair removal, Skin rejuvenation
Central wavelength at 25℃
Germany Jenoptik bar
Laser stack type
Micro channel cooled vertical diode laser stack
Per bar power
Maximum operating voltage
Fast axis divergence (FWHM)
Slow axis divergence (FWHM)
Typical pitch per bar
Micro channel cooler + Water + TEC
Water cooling condition
1.Flow rate: 0.3L/min ±10% / bar 2.water temperature: 15~25℃ 3.Water quality: Deionized 2-10 µs/cm, mixed bed ion exchanger,particle filter<25µm
4.Cooling: Don't use any material that combined with copper, that would form galvanic elements